How do I measure the flatness of 6061 T651 Aluminum Plate? - Printable Version +- Forums (https://askaluminium.com) +-- Forum: My Category (https://askaluminium.com/forumdisplay.php?fid=1) +--- Forum: aluminium faq (https://askaluminium.com/forumdisplay.php?fid=2) +--- Thread: How do I measure the flatness of 6061 T651 Aluminum Plate? (/showthread.php?tid=7946)

How do I measure the flatness of 6061 T651 Aluminum Plate? - ZellaHyday - 07-20-2018 The method that is use in most cases is 2 foot short span. I will make the assumption that the 6061T651 Aluminum plate has been purchased to “Type 200® wrought tooling plate or Precision Plate®” specification. If not, standard Aluminum Association tolerance of .100” for thickness of 0.250”–0.624” and .075” for thickness of 0.625”-8.000” would apply (Table 7.18*). A certified 24” straight edge is used in conjunction with certified taper gage or feeler gages and a relatively flat inspection surface.   The material to be measured should be oriented with the concave surface facing up. The straight edge is now positioned to span any 2 foot segment of the plate in any horizontal direction. The straight edge must contact the surface of the material at 2 opposite points. If you cannot fit a .060” thick taper gage under the straight edge (between the 2 opposite high points) the material is within Aluminum Association Flatness tolerances.