12-07-2018, 01:37 AM
That was my first thougt....but 1/8" thick would be pushing it for tinsnips.
Air powered die grinder would go through it like butter. Dremel would also work well, or a hacksaw if none of the other options are available. Al is not hard to cut.
My first choice would be Dremel, because a hacksaw might leave burrs/jagged edges, where a dremel would generally leave it pretty smooth. Plus, you could finish it up with other dremel attachments to smooth out any rough edges left behind.
Air powered die grinder would go through it like butter. Dremel would also work well, or a hacksaw if none of the other options are available. Al is not hard to cut.
My first choice would be Dremel, because a hacksaw might leave burrs/jagged edges, where a dremel would generally leave it pretty smooth. Plus, you could finish it up with other dremel attachments to smooth out any rough edges left behind.